Moog-music Minimoog Voyager XL Manuel d'utilisateur télécharger pdf (Page 51)

Page 52

Voyager XL User’s Manual - EDIT Mode

Page 53

Voyager XL User’s Manual - EDIT Mode

2.3 PGM PEDAL SOURCE (Programmable Pedal Source)

PGM PEDAL SOURCE allows you to program one of 8 additional

modulation sources to be used when the Pedal/ON Bus SOURCE control

is set to ‘NOISE/PGM’. To select a source, use the -1/+1 buttons to

highlight the desired selection and press ENTER.

The available sources are:

Noise (default) Oscillator 1

Filter ENV Oscillator 2

Volume ENV Touch Surface X

Smoothed Sample and Hold Touch Surface Y

2.4 PGM PEDAL DEST. (Programmable Pedal Destination):

PGM PEDAL DEST allows you to program one of 8 additional modulation

destinations to be used when the Pedal/ON Bus DESTINATION control

is set to ‘LFO RATE/PGM’. To select a destination, use the -1/+1 buttons

to highlight the desired selection and press ENTER.

The available destinations are:

LFO Rate (default) Osc. 1 Level

Filter Resonance Osc. 2 Level

Filter Spacing Osc. 3 Level

Panorama Noise Level

3.1 PGM SHAPING 1 SRC (Programmable Shaping 1 Source)

3.2 PGM SHAPING 2 SRC (Programmable Shaping 2 Source):

There are two programmable shaping sources. Both shaping sources are

identical, and both are combined by the software and shared by both Mod

Busses. When either of the Mod Bus SHAPING controls are in the

‘ON/PGM’ position, the programmable shaping values stored in memory

are applied to shape the Mod Buss source signal. Shaping is like an

additional level control for the modulation amount. As an example, if

Velocity is used as a shaping source, the higher the velocity value, the

more the Mod Source is passed to the Destination. PROGRAMMABLE

SHAPING SOURCE 1/2 also allows an offset value to be applied, which is

added to the shaper itself.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 99 100

Pas de commentaire

Moog-music Minimoog Voyager XL Manuel d'utilisateur Page 51