Moog-music CP-251 Moogerfooger Control Processor Manuel d'utilisateur télécharger pdf (Page 21)

Turn down the monitor amp to a comfortable level. You’ll hear frequency modulation

of the carrier oscillator by the two LFO waveforms. MIXER IN 1 and IN 2 determine the

strengths of the individual LFO waveforms, MASTER sets the overall strength of the dual

LFO waveform, and OFFSET raises and lowers the voltage at the center of the dual LFO

waveform, thereby raising and lowering the pitch of the carrier oscillator.

Now disconnect the monitor amp from the CARRIER OUT jack and connect it to the

MF102 AUDIO OUT jack. Connect your instrument the the MF102’s AUDIO IN. Set MIX to

“ 10” and AMOUNT to “ 0” . Listen to the effect of the dual LFO modulation on your

instrument’s ring-modulated signal.

Figure 14 - Setup for dual LFO modulation.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Moog-music CP-251 Moogerfooger Control Processor Manuel d'utilisateur Page 21